Ara
Toplam kayıt 32, listelenen: 21-30
Masif ve Lamine ağaç malzemelerin (LAM) Alyan Vida tutma mukavemeti
(2009)
Bu çalışmada, farklı ağaç türlerinden hazırlanan, polivinilasetat (PVAc) ve üre-formaldehit (ÜF) tutkallarıyla yapıştırılmış lamine malzemelerin (LVL), liflere dik ve paralel doğrultudaki alyan vida tutma performansları, ...
Experimental and numerical analysis of mounting force of auxetic dowels for furniture joints
(Elsevier Ltd, 2021)
Limited number of papers describe the practical use of auxetics in the wood and furniture sector. Only one paper describes the auxetic nails. None of them analyzed the impact of using auxetics on the strength of furniture ...
Bending Moment Capacities of L-Shaped Mortise and Tenon Joints under Compression and Tension Loadings
(North Carolina State Univ Dept Wood & Paper Sci, 2015)
Tests were carried out to determine the bending moment capacities of L-shaped mortise and tenon furniture joints under both compression and tension loadings. The effects of wood species (Turkish beech and Scotch pine), ...
Static Front to Back Loading Capacity of Wood Chairs and Relationship between Chair Strength and Individual Joint Strength
(North Carolina State Univ Dept Wood & Paper Sci, 2016)
The relationship between the static front to back loading capacity of chairs and the moment capacities of the joints used in their side frames was investigated. The secondary purpose of the study was to determine the effect ...
STRUCTURAL ANALYSES OF WOODEN CHAIRS BY FINITE ELEMENT METHOD (FEM) AND ASSESSMENT OF THE CYCLIC LOADING PERFORMANCE TN COMPARISON WITH ALLOWABLE DESIGN LOADS
(Universidad del Bio-Bio, 2021)
Tests were carried out to investigate the cyclic loading performance of chairs constructed of Scotch pine (Pinus sylvestris) and Oriental beech (Fagus orientalis). Totally, 30 real size chairs were constructed and assembled ...
Ultimate Failure Load and Stiffness of Screw Jointed Furniture Cabinets Constructed of Particleboard and Medium-Density Fiberboard
(Forest Products Soc, 2011)
The objective of this study was to investigate the effects of material type, screw diameter, and screw length on ultimate failure load and stiffness of four-sided furniture cabinets. In total, 81 four-sided test cabinets ...
Numerical Analyses of Various Sizes of Mortise and Tenon Furniture Joints
(North Carolina State Univ Dept Wood & Paper Sci, 2016)
This study reports the moment resistance, stiffness, and numerical analysis of various sizes of round-end mortise and tenon joints. L-shaped and T-shaped specimens were constructed. Joints were manufactured using three ...
Utilizing Poppy Husk-based Particleboards as an Alternative Material in Case Furniture Construction
(North Carolina State Univ Dept Wood & Paper Sci, 2017)
Particleboard can be defined as a wood-based panel produced under pressure and heat with the inclusion of wood particles or other lignocellulosic materials and an adhesive. The need for alternative resources to replace ...
Estimation equations for moment resistances of L-type screw corner joints in case goods furniture
(Forest Products Soc, 2008)
The effects of the number of screws and screw sizes on bending moment resistance of L-type furniture corner joints constructed of particleboard (PB) and medium density fiberboard (MDF) with resin Surfacing were investigated ...
Moment capacity of traditional and alternative T-type end-to-side-grain furniture joints
(Forest Products Soc, 2005)
The bending moment capacity of traditional and alternative T-type end-to-side-grain joints constructed of Oriental beech (Fagus orientalis Lipsky), European oak (Quercus borealis Lipsky), and Scotch pine (Pinus sylvestris ...