Ara
Toplam kayıt 26, listelenen: 11-20
Static Front to Back Loading Capacity of Wood Chairs and Relationship between Chair Strength and Individual Joint Strength
(North Carolina State Univ Dept Wood & Paper Sci, 2016)
The relationship between the static front to back loading capacity of chairs and the moment capacities of the joints used in their side frames was investigated. The secondary purpose of the study was to determine the effect ...
STRUCTURAL ANALYSES OF WOODEN CHAIRS BY FINITE ELEMENT METHOD (FEM) AND ASSESSMENT OF THE CYCLIC LOADING PERFORMANCE TN COMPARISON WITH ALLOWABLE DESIGN LOADS
(Universidad del Bio-Bio, 2021)
Tests were carried out to investigate the cyclic loading performance of chairs constructed of Scotch pine (Pinus sylvestris) and Oriental beech (Fagus orientalis). Totally, 30 real size chairs were constructed and assembled ...
Ultimate Failure Load and Stiffness of Screw Jointed Furniture Cabinets Constructed of Particleboard and Medium-Density Fiberboard
(Forest Products Soc, 2011)
The objective of this study was to investigate the effects of material type, screw diameter, and screw length on ultimate failure load and stiffness of four-sided furniture cabinets. In total, 81 four-sided test cabinets ...
Numerical Analyses of Various Sizes of Mortise and Tenon Furniture Joints
(North Carolina State Univ Dept Wood & Paper Sci, 2016)
This study reports the moment resistance, stiffness, and numerical analysis of various sizes of round-end mortise and tenon joints. L-shaped and T-shaped specimens were constructed. Joints were manufactured using three ...
Utilizing Poppy Husk-based Particleboards as an Alternative Material in Case Furniture Construction
(North Carolina State Univ Dept Wood & Paper Sci, 2017)
Particleboard can be defined as a wood-based panel produced under pressure and heat with the inclusion of wood particles or other lignocellulosic materials and an adhesive. The need for alternative resources to replace ...
Theoretical analysis and design of joints in a representative sofa frame constructed of plywood and oriented strandboard
(Forest Products Soc, 2008)
Increasingly, plywood and oriented strandboard (OSB) are being used in the construction of upholstered furniture frames. There is little information available, however, concerning the strength of frames constructed with ...
Estimation equations for moment resistances of L-type screw corner joints in case goods furniture
(Forest Products Soc, 2008)
The effects of the number of screws and screw sizes on bending moment resistance of L-type furniture corner joints constructed of particleboard (PB) and medium density fiberboard (MDF) with resin Surfacing were investigated ...
Comparison of mechanical properties of solid wood and laminated veneer lumber fabricated from Turkish beech, Scotch pine, and Lombardy poplar
(Forest Products Soc, 2009)
Selected mechanical properties of laminated veneer lumber (LVL) prepared from Turkish beech (Fagus orientalis L.), Scotch pine (Pinus sylvestris L.), and Lombardy poplar (Populus nigra) veneers bonded with polyvinyl acetate ...
Moment resistance of multiscrew L-type corner joints
(Forest Products Soc, 2005)
This study investigated the effects of screw diameter and length, loading, board material, board surface condition, and gluing, on moment resistances of three-screw L-type corner joints. Wood-based composite panels utilized ...
Withdrawal strength and moment resistance of screwed T-type end-to-side grain furniture joints
(Forest Products Soc, 2004)
Tests were carried out to investigate the withdrawal strength and bending moment resistance of screwed T-type, end-to-side grain joints constructed of Turkish beech (Fagus Orientalis L.), European oak (Quercus petraea L.), ...