Ara
Toplam kayıt 28, listelenen: 11-20
Shear force and bending moment capacities of joints constructed with glued corner blocks
(Forest Products Soc, 2006)
Tests were carried out to determine the ultimate shear and bending moment capacities of glued corner blocks under controlled laboratory conditions. Yellow-poplar and sweetgum were utilized in constructing the joint specimens, ...
Bending Moment Capacities of L-Shaped Mortise and Tenon Joints under Compression and Tension Loadings
(North Carolina State Univ Dept Wood & Paper Sci, 2015)
Tests were carried out to determine the bending moment capacities of L-shaped mortise and tenon furniture joints under both compression and tension loadings. The effects of wood species (Turkish beech and Scotch pine), ...
Effect of the number of screws and screw size on moment capacity of furniture corner joints in case construction
(Forest Products Soc, 2008)
Tests were carried out in order to determine the bending moment capacity of L-type glued-screwed coner joints constructed with multiple screws. 6 sizes of screws were used for assembling the specimens. 2, 3, and 4 screws ...
Static Front to Back Loading Capacity of Wood Chairs and Relationship between Chair Strength and Individual Joint Strength
(North Carolina State Univ Dept Wood & Paper Sci, 2016)
The relationship between the static front to back loading capacity of chairs and the moment capacities of the joints used in their side frames was investigated. The secondary purpose of the study was to determine the effect ...
Ultimate Failure Load and Stiffness of Screw Jointed Furniture Cabinets Constructed of Particleboard and Medium-Density Fiberboard
(Forest Products Soc, 2011)
The objective of this study was to investigate the effects of material type, screw diameter, and screw length on ultimate failure load and stiffness of four-sided furniture cabinets. In total, 81 four-sided test cabinets ...
Numerical Analyses of Various Sizes of Mortise and Tenon Furniture Joints
(North Carolina State Univ Dept Wood & Paper Sci, 2016)
This study reports the moment resistance, stiffness, and numerical analysis of various sizes of round-end mortise and tenon joints. L-shaped and T-shaped specimens were constructed. Joints were manufactured using three ...
Utilizing Poppy Husk-based Particleboards as an Alternative Material in Case Furniture Construction
(North Carolina State Univ Dept Wood & Paper Sci, 2017)
Particleboard can be defined as a wood-based panel produced under pressure and heat with the inclusion of wood particles or other lignocellulosic materials and an adhesive. The need for alternative resources to replace ...
Theoretical analysis and design of joints in a representative sofa frame constructed of plywood and oriented strandboard
(Forest Products Soc, 2008)
Increasingly, plywood and oriented strandboard (OSB) are being used in the construction of upholstered furniture frames. There is little information available, however, concerning the strength of frames constructed with ...
Estimation equations for moment resistances of L-type screw corner joints in case goods furniture
(Forest Products Soc, 2008)
The effects of the number of screws and screw sizes on bending moment resistance of L-type furniture corner joints constructed of particleboard (PB) and medium density fiberboard (MDF) with resin Surfacing were investigated ...
Comparison of mechanical properties of solid wood and laminated veneer lumber fabricated from Turkish beech, Scotch pine, and Lombardy poplar
(Forest Products Soc, 2009)
Selected mechanical properties of laminated veneer lumber (LVL) prepared from Turkish beech (Fagus orientalis L.), Scotch pine (Pinus sylvestris L.), and Lombardy poplar (Populus nigra) veneers bonded with polyvinyl acetate ...