Ara
Toplam kayıt 17, listelenen: 1-10
LOWER TOLERANCE LIMIT APPROACH TO EQUATION-BASED RATIONAL DESIGN VALUES FOR L-SHAPED MORTISE AND TENON JOINTS
(Soc Wood Sci Technol, 2017)
Statistical lower tolerance limits (LTLs) were computed for the ratios obtained by dividing the test values for 360 L-shaped rectangular mortise and tenon joints consisting of 72 different configurations of five specimens ...
TECHNICAL NOTE: LOWER TOLERANCE LIMIT APPROACH TO EQUATION-BASED RATIONAL DESIGN VALUES FOR T-SHAPED MORTISE AND TENON JOINTS
(Soc Wood Sci Technol, 2017)
A nonlinear regression expression was fitted to the test data obtained from a study of the bending moment capacity of 320 rectangular T-shaped mortise and tenon furniture joints consisting of 64 configurations of five ...
RELATIONSHIP BETWEEN STATIC AND CYCLIC FRONT TO BACK LOAD CAPACITY OF WOODEN CHAIRS, AND EVALUATION OF THE STRENGTH VALUES ACCORDING TO ACCEPTABLE DESIGN VALUES
(Soc Wood Sci Technol, 2018)
Tests were carried out to investigate the relationship between static and cyclic strength of wooden chairs. Furthermore, cyclic front to back load performance of chairs were compared with acceptable design loads that were ...
Montaja hazır koltuk iskeletlerinin mukavemetinin sonlu elemanlar analizi ile belirlenmesi
(2007)
Bu çalışmada, ağaç ve ağaç esaslı (kompozit) malzemelerden tutkalsız-vidalı (demonte) olarak üretilmiş koltuk iskeletlerinin mukavemet özellikleri araştırılmıştır. Ayrıca, koltuk yan düzlem çerçevesinde, ara kayıtın yeri ...
Shear force and bending moment capacities of joints constructed with glued corner blocks
(Forest Products Soc, 2006)
Tests were carried out to determine the ultimate shear and bending moment capacities of glued corner blocks under controlled laboratory conditions. Yellow-poplar and sweetgum were utilized in constructing the joint specimens, ...
Ultimate Failure Load and Stiffness of Screw Jointed Furniture Cabinets Constructed of Particleboard and Medium-Density Fiberboard
(Forest Products Soc, 2011)
The objective of this study was to investigate the effects of material type, screw diameter, and screw length on ultimate failure load and stiffness of four-sided furniture cabinets. In total, 81 four-sided test cabinets ...
Numerical Analyses of Various Sizes of Mortise and Tenon Furniture Joints
(North Carolina State Univ Dept Wood & Paper Sci, 2016)
This study reports the moment resistance, stiffness, and numerical analysis of various sizes of round-end mortise and tenon joints. L-shaped and T-shaped specimens were constructed. Joints were manufactured using three ...
Utilizing Poppy Husk-based Particleboards as an Alternative Material in Case Furniture Construction
(North Carolina State Univ Dept Wood & Paper Sci, 2017)
Particleboard can be defined as a wood-based panel produced under pressure and heat with the inclusion of wood particles or other lignocellulosic materials and an adhesive. The need for alternative resources to replace ...
Theoretical analysis and design of joints in a representative sofa frame constructed of plywood and oriented strandboard
(Forest Products Soc, 2008)
Increasingly, plywood and oriented strandboard (OSB) are being used in the construction of upholstered furniture frames. There is little information available, however, concerning the strength of frames constructed with ...
Estimation equations for moment resistances of L-type screw corner joints in case goods furniture
(Forest Products Soc, 2008)
The effects of the number of screws and screw sizes on bending moment resistance of L-type furniture corner joints constructed of particleboard (PB) and medium density fiberboard (MDF) with resin Surfacing were investigated ...