Ara
Toplam kayıt 9, listelenen: 1-9
LOWER TOLERANCE LIMIT APPROACH TO EQUATION-BASED RATIONAL DESIGN VALUES FOR L-SHAPED MORTISE AND TENON JOINTS
(Soc Wood Sci Technol, 2017)
Statistical lower tolerance limits (LTLs) were computed for the ratios obtained by dividing the test values for 360 L-shaped rectangular mortise and tenon joints consisting of 72 different configurations of five specimens ...
Shear force and bending moment capacities of joints constructed with glued corner blocks
(Forest Products Soc, 2006)
Tests were carried out to determine the ultimate shear and bending moment capacities of glued corner blocks under controlled laboratory conditions. Yellow-poplar and sweetgum were utilized in constructing the joint specimens, ...
Effect of the number of screws and screw size on moment capacity of furniture corner joints in case construction
(Forest Products Soc, 2008)
Tests were carried out in order to determine the bending moment capacity of L-type glued-screwed coner joints constructed with multiple screws. 6 sizes of screws were used for assembling the specimens. 2, 3, and 4 screws ...
Theoretical analysis and design of joints in a representative sofa frame constructed of plywood and oriented strandboard
(Forest Products Soc, 2008)
Increasingly, plywood and oriented strandboard (OSB) are being used in the construction of upholstered furniture frames. There is little information available, however, concerning the strength of frames constructed with ...
Comparison of mechanical properties of solid wood and laminated veneer lumber fabricated from Turkish beech, Scotch pine, and Lombardy poplar
(Forest Products Soc, 2009)
Selected mechanical properties of laminated veneer lumber (LVL) prepared from Turkish beech (Fagus orientalis L.), Scotch pine (Pinus sylvestris L.), and Lombardy poplar (Populus nigra) veneers bonded with polyvinyl acetate ...
Moment resistance of multiscrew L-type corner joints
(Forest Products Soc, 2005)
This study investigated the effects of screw diameter and length, loading, board material, board surface condition, and gluing, on moment resistances of three-screw L-type corner joints. Wood-based composite panels utilized ...
Withdrawal strength and moment resistance of screwed T-type end-to-side grain furniture joints
(Forest Products Soc, 2004)
Tests were carried out to investigate the withdrawal strength and bending moment resistance of screwed T-type, end-to-side grain joints constructed of Turkish beech (Fagus Orientalis L.), European oak (Quercus petraea L.), ...
Determination of the strength performance of chair frames constructed of solid wood and wood composites
(Forest Products Soc, 2006)
In this study, the strength properties of glued-doweled and screw jointed chair frames constructed of solid wood and wood-based (composite) materials were investigated. Scotch pine (Pinus Syivestris Lipsky) and Turkish ...
Shear Force Capacities of H-Type Furniture Joints Constructed of Various Heat-Treated Wood Species
(ZAGREB UNIV, 2023)
The aim of this study was to investigate the effect of wood species, heat treatment, adhesive type and joint technique on shear force capacity of H-type furniture joints. For this purpose, an experimental design that ...