Ara
Toplam kayıt 6, listelenen: 1-6
Radiometric measurement of lignite coal and its by-products and assessment of the usability of fly ash as raw materials in Turkey
(Walter de Gruyter Gmbh, 2018)
Lignite coal (LC) is a key energy source for electricity generation in Turkey. During lignite burning, huge amounts of fly ash (FA), bottom ash and slag are produced as by-products which contain radionuclides in the natural ...
Research of production of CO2 from non-condensable gases in geothermal fluid and cost analysis
(Pergamon-Elsevier Science Ltd, 2017)
In this research, we studied the techniques for production of CO2 by using non-condensable gas containing CO2 at a rate of 96%, obtained from the condenser of the thermal plant set up at Kizildere Geothermal area. Moreover, ...
A SURVEY ON ELEMENTAL DISTRIBUTIONS OF VOLCANIC TUFF QUARRIES IN TURKEY
(Parlar Scientific Publications (P S P), 2017)
Volcanic tuff stones are widely used as coating materials for insulation and/or ornamental purposes in the construction sectors in Turkey. Some volcanic tuff quarries are close to the residential areas, water resources and ...
Türkiye’deki Feldspat Rezervlerinde Radyoaktivite Düzeyleri
(2019)
Yer kabuğunun %60’ını oluşturan feldspat, en önemli mineral gruplarındandır. Magmanın farklı kısımlarında değişik şekillerde bulunan bu minerallerin soğuyup kristalleşmesiyle feldspat zonları ve yatakları oluşmuştur. ...
Thermo-economic analysis of pipe insulation for district heating piping systems
(Pergamon-Elsevier Science Ltd, 2011)
In this study, the optimum insulation thickness of pipes used in district heating pipeline networks, energy savings over a lifetime of 10 years, and payback periods are calculated for the five different pipe sizes and four ...
EFFECTS OF CUTTING PARAMETERS AND TOOL-PATH STRATEGIES ON TOOL ACCELERATION IN BALL-END MILLING
(Inst Za Kovinske Materiale I in Tehnologie, 2017)
The determination of the cutting-parameter values that cause increases in vibration values is important to minimize the errors that can occur. Thus, the first aim of this study was to investigate the optimum cutting-parameter ...