Ara
Toplam kayıt 122, listelenen: 81-90
Effect of hole diameter, hole distance from the edge, and material properties on lateral pin holding strength of medium density fiberboard and particleboard
(Forest Products Soc, 2004)
There is no established standard which evaluates the lateral holding resistance of wood composites. The method of test offered in this study intends to determine the lateral resistance of panels used in case constructions ...
Some mechanical properties of wood impregnated with environmentally- friendly boron and copper based chemicals
(Slovak Forest Products Research Inst, 2013)
The aim of this study was made to determine some mechanical properties such as compression strength parallel to grain (CSPG), modulus of rupture (MOR), and modulus of elasticity (MOE) of wood treated with some boron and ...
Mapping of laminar separation bubble and bubble-induced vibrations over a turbine blade at low Reynolds numbers
(PERGAMON-ELSEVIER SCIENCE LTD, 2021)
A detailed experimental investigation on the mapping of the LSB formation over a turbine blade with different airfoils, and their vibration effects were considered first in this study. Wind tunnel experiments were performed ...
Performance analysis of a textile based solar assisted air source heat pump with the energy and exergy methodology
(Elsevier Ltd, 2021)
Solar air collectors are integrated into the air source heat pump in order to increase the performance of the heat pump in cold climate regions. The evaporator air is heated by solar air collectors. In this study, two ...
Increasing the physical and combustion performance of Oriental beech by impregnating borates and coating liquid glass
(ASSOC BRASIL POLIMEROS, 2021)
This study was designed to investigate physical properties such as color changes after weathering and water absorption (WA) levels, and combustion performance of borates-impregnated and LG-coated Oriental beech wood. Results ...
Prediction of the effect of insulation thickness and emission on heating energy requirements of cities in the future
(Elsevier Ltd, 2021)
This study predicts the effect of insulation thickness on residential- and population-sourced energy demands and emission amounts in the future with a new method. Attempts are made to determine the future population increase ...
Improvement of technological properties of wood plastic composites reinforced with glass and carbon fibre fabric
(SAGE Publications Ltd, 2021)
In this study, HDPE-based flat-pressed WPCs were reinforced with glass fibre and carbon fibre woven fabrics, which could be used where high strength and stiffness are required. The effect of reinforcement on some physical, ...
Comprehensive transient analysis on control system in a photovoltaic power plant under lightning strike
(Elsevier, 2022)
Solar power plants are installed in high and open places to receive high solar radiation. However, this leaves them vulnerable to lightning strike. Lightning strike affects power plants in two ways, directly and indirectly. ...
Environmental impact assessment of a real geothermal driven power plant with two-stage ORC using enhanced exergo-environmental analysis
(PERGAMON-ELSEVIER SCIENCE LTD, 2022)
Geothermal driven power plants (GPPs) with two-stage ORC are mostly used in low-temperature geothermal fields around the World. The environmental impacts of these GPPs create a gap in the literature. In this study, enhanced ...
Performance evaluation of novel photovoltaic and Stirling assisted hybrid micro combined heat and power system
(PERGAMON-ELSEVIER SCIENCE LTD, 2022)
Since both heat and electricity are produced in the cogeneration system, residential heating can be done independently from the grid. Stirling engine is proposed to use for rural areas where electricity cannot reach. It ...